Safety Note; Installing And Uninstalling Stand Base - Sanyo LCD-42E40W User Manual

User manual
Table of Contents

Advertisement

Available languages

Available languages

INSTALLING AND UNINSTALLING STAND BASE

Handling with more than two people is recommended when installing.
When holding (moving or lifting) the LCD Display, hold the display's body. Do not handle the LCD TV by holding
the attached accessory parts (speakers), otherwise it may result in damage.
Before installing, provide a desk (or a part of it) which is strong enough to support the weight of the LCD TV
and its stand. The desk must be larger than the LCD Display's screen size. The desk's surface must be flat and
maintained with soft material (such as a blanket) for protecting the screen surface.
Before putting the LCD Display on the desk, make sure there is no object on it. Leaving any object under the
screen may cause damage on the screen.
The LCD TV with this stand should be installed on flat and le\vel place. Do not place it on non flat, unlevel or
unstable cart or stand. The display may fall, causing not only serious damage to the products but serious injury
to a person.
For correct installing, mounting and uninstalling of the LCD TV Stand, it is strongly recommended to use a trained,
authorized dealer. Failure to follow correct procedures could result in damage to the equipment or injury to the
installer.
Installing Stand Base (42")
1 Place the LCD TV on a flat surface place where
maintained with soft materials (such as a blanket) for
protecting the display screen.
For correct installing, mounting and uninstalling LCD TV Stand, it is strongly recommended to use a trained,
authorized dealer. Failure to follow correct procedures could result in damage to the equipment or injury to the
installer.
Uninstalling Stand Base (42")
1 Place the LCD TV screen facing down on a flat
surface place where maintained with soft materials
(such as a blanket) for protecting the display screen.
CAUTION INSTALLING STAND BASE

SAFETY NOTE

2 Remove screws in 4 holes with screw driver.
1
2
3
4
UNINSTALLING STAND BASE
2 Remove screws in 4 holes with screw driver.
1
2
3
4
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents