Product Identification; Optional Product Features; Installation - Desa VVSR18 Owner's Operation And Installation Manual

Grate
Burner
Pan
Burner Clamp
Burner Manifold
Figure 1 - Product Identification (Dual Burner Shown)
ON/OFF SAFETY VALVE/PILOT KIT
AND PROPANE/LP CONVERSION
An optional valve/safety pilot kit with a piezo
ignitor is available for this appliance. This sys-
tem requires no matches, batteries, or other
sources to light. You must use this optional
system for LP conversion. See Accessories,
page 24.
REMOTE CONTROL READY
(MILLIVOLT) SAFETY VALVE/
PILOT KIT
An optional millivolt valve/safety pilot kit with
a piezo ignitor is available for this appliance.
This system requires no matches, batteries,
CAUTION: Do not remove
the data plates attached to the
burner pan. The data plates
contain important warranty and
safety information.
124183-01B

PRODUCT IDENTIFICATION

Grate
Steps

OPTIONAL PRODUCT FEATURES

INSTALLATION

www.desatech.com
Hearth Kit Model ___________________
Serial Number _____________________
Log Set Model _____________________
Burner Inlet
Fitting
or other sources to light. This system may
be connected to a wall switch or hand-held
wireless remote control. See Accessories,
page 24.
REMOTE CONTROL ACCESSORIES
There is an optional hand-held ON/OFF re-
mote control that can be purchased separately
for this log set. You must use the millivolt
valve/safety pilot kit to use remote acces-
sories with this appliance. See Accessories,
page 24.
A wall switch is also available for this appli-
ance. You must use the millivolt valve/safety
pilot kit to use the wall switch with this appli-
ance. See Accessories, page 24.
WARNING: Before installing
in a solid fuel burning fireplace,
the chimney flue and firebox
must be cleaned of soot, creo-
sote, ashes and loose paint by a
qualified chimney cleaner. Creo-
sote will ignite if highly heated.
A dirty chimney flue may create
and distribute soot within the
house. Inspect chimney flue for
damage. If damaged, repair flue
before operating heater.
5