Advertisement
Lavatory Lift Rod and Waste Assembly
1. Thoroughly clean around drain opening in lavatory sink. Apply
1/4 inch bead of plumber's putty (not furnished) around the bot-
tom side of seat.
2. Apply pipe joint compound or Teflon tape (not furnished) to top
threaded end of the drain body. Slip drain body up through the
drain opening and screw seat on the drain body.
3. Position the drain body with pivot rod opening extending rear-
ward and tighten mounting nut until the drain body is snug. Wipe
excess plumber's putty from the seat area. Apply pipe joint com-
pound (not furnished) to top threaded end of tailpipe and screw
into drain body. Tighten firmly by hand.
4. Position drain plug in either of the following ways:
A. VANDALPROOF - this design is to prevent unauthorized re-
moval of the drain plug. Unscrew the pivot nut and remove the
pivot rod. Inside the drain body position the pivot rod through the
drain plug hole as shown in the illustration below. Screw the pivot
nut back on the drain body. DO NOT OVERTIGHTEN.
A. VANDALPROOF
PIVOT
ROD
B. EASY REMOVAL - This design is for quick removal of drain
plug for cleaning. Just drop in the drain plug as shown in the
illustration below.
POSITION FOR
EASY REMOVAL
PIVOT
ROD
5. Install lift rod, with knob attached, into top of spout as shown.
Secure lift rod strap to bottom end of lift rod as shown. With pivot
rod in the down position, assemble strap to pivot rod using the
spring clip. The strap will have to be bent to reach the pivot rod
on some installations. Adjustment may be required so lift rod
clears spout tube and connection (i.e., bend spout tube out-
wards).
6. With the drain plug in full open position, adjust lift rod and knob
to clear faucet and tighten lift rod strap screw.
F
P
AUCET
ARTS
VANDALPROOF
POSITION
B. EASY REMOVAL
CARTRIDGE
ESCUTCHEON
MOUNTING NUT
MOUNTING
WASHER
CAUTION: To avoid the lift rod
knob rubbing against spout, do
not install rod any lower than
dimension shown.
DRAIN
PLUG
SEAT
MOUNTING
NUT
DRAIN
BODY
8"
PIPE
JOINT
COMPOUND
OR
TEFLON
TAPE (NOT
FURNISHED)
KNOB
INSERT
HANDLE
SCREW
HANDLE
KNOB
LIFT ROD
AND KNOB
STEM
FLOW RATOR
GUIDE
AERATOR
CARTRIDGE
NUT
SPOUT
ASSEMBLY
STEM
EXTENSION
SPOUT MOUNTING
WASHER
SPOUT
MOUNTING NUT
SPOUT
UNION TEE
MOUNTING
NUT
WATER
SUPPLY LINE
LIFT ROD
AND KNOB
SPOUT
VANDAL-
PROOF
HOLE
PIPE
2-1/8"
JOINT
COMPOUND
OR
LIFT
TEFLON
ROD
TAPE (NOT
STRAP
FURNISHED)
1-1/2"
BOTTOM
GASKET
FLAT
WASHER
PIVOT
NUT
PIVOT
ROD SEAT
LIFT ROD
1-1/4"
STRAP
SHOWN
TAILPIECE
IN BENT
POSITION
LIFT
ROD
STRAP
SCREW
SPRING
CLIP
PIVOT
ROD
Advertisement
