Advertisement
The Odyssey series clock displays the current time in 12 hour format. The high
brightness display matches our other Odyssey, STR, and VFD3 series gauges and has
the same night brightness dimming capability.
Operation:
The gauge needs the red, orange, and black wires connected to operate. The red
wire should have switched 12 volt power from an ACC. point on the fuse panel. The
orange wire should have constant 12 volt power. The black wire should be connected to
a good ground point. When the blue wire has 12 volts, it will dim the display for night
viewing.
Setting the time:
The remote mounted red and black push buttons will be used to set the clock. The
BLACK "set" button advances hours, the RED "set" button advances minutes. Each time
that you make a change to either the hours or minutes, the seconds are reset to zero.
Adjusting the accuracy:
The clock is accurate to +/-2 minutes a month as it is sent. It can be tuned for
better accuracy if desired. Press and hold both of the set buttons for several seconds.
The clock will display "C 0". The "C" indicates that it is in the calibration mode and the
second number is the current calibration value. The calibration value indicates the
number of seconds to add or subtract each day. The clock can be adjusted from +7
sec/day to -7 sec/day.
Press the minute set button to change the cal value. Press the hour set button to
return to normal clock operation.
Wiring:
BLACK
-
RED
-
ORANGE
-
BLUE
-
Problem
Clock will not light up
Clock will not turn off when
the key is off.
Clock lights up, but does
not read correctly.
connect to a good ground point in the vehicle.
connect to switched 12 volt power point.
(An accessory terminal will work for this.)
connect to a constant 12 volt power point.
(This will keep the correct time.)
connect to the tail light circuit.
Troubleshooting guide.
Possible cause
Red wire does not have
power.
Orange wire does not have
power.
Black wire is not getting
a good ground.
Power is reversed.
Clock is damaged.
The red and orange wires
are reversed.
Loose connection on orange
power wire.
Solution
Connect to a location that has power
when the key is on.
Connect to a location that has power
all of the time.
Connect ground to a different location.
Connect black to negative ground, red and
orange to +12V power.
Return clock for repair. (see instructions)
Connect the red to switched power, the
orange to constant power.
Reconnect orange wire.
MAN#650277
Advertisement
