Advertisement
Quick Links
Right Rear
Left Rear
Do not bundle or route the solenoid
and sensor wires together!
RIGHT FRONT DOWN (+) GREEN
LEFT FRONT DOWN (+) RED
RIGHT FRONT UP (+) BLACK
LEFT FRONT UP (+) WHITE
RIGHT REAR DOWN (+) GREEN
LEFT REAR DOWN (+) RED
RIGHT REAR UP (+) BLACK
LEFT REAR UP (+) WHITE
CONNECT TO GROUND BLACK
PARK/NEUTRAL INPUT (-) [ground if not used] WHITE/BLUE
FUSED, CONSTANT 12 VOLT POWER RED
FUSED, 12 VOLT ACCESSORY POWER YELLOW
DISPLAY DIMMING INPUT (+) BLUE
TANK PRESSURE SENDER GRAY
Air
Tank
LEFT FRONT
HEIGHT SENSOR
RIGHT FRONT
HEIGHT SENSOR
Wiring Overview
IMPORTANT:
Make sure to always disconnect the negative cable from the battery if you are going to
be working on or under the vehicle. Failure to do so can result in serious injury if the system is
accidentally activated.
DHC-2000/DHC-2100 rev. C
Digital Height Control System
GREEN
BROWN
SEN-03-1
Bag
PURPLE
ORANGE
SEN-03-1
Bag
ONLY USED WITH
PRESSURE ONLY OR
HEIGHT-PRESSURE
COMBINATION
To FRONT air
solenoid block
To REAR air
solenoid block
SEN-03-5
GROUND
Left Front
SEN-03-1
Bag
Right Front
SEN-03-1
Bag
Dakota Digital
DHC-2000
DIGITAL HEIGHT
CONTROL SYSTEM
1
OPTIONAL
REMOTE
CONTROL
ANTENNA
ONLY USED WITH
HEIGHT ONLY OR
HEIGHT-PRESSURE
COMBINATION
RIGHT REAR
HEIGHT SENSOR
LEFT REAR
HEIGHT SENSOR
Display
MAN# 650031C
Advertisement
Related Manuals for Dakota Digital DHC-2000
Summary of Contents for Dakota Digital DHC-2000
- Page 1 SEN-03-1 SEN-03-1 ANTENNA ONLY USED WITH PRESSURE ONLY OR HEIGHT-PRESSURE COMBINATION Do not bundle or route the solenoid Dakota Digital and sensor wires together! DHC-2000 DIGITAL HEIGHT CONTROL SYSTEM To FRONT air solenoid block RIGHT FRONT DOWN (+) GREEN LEFT FRONT DOWN (+) RED...
- Page 2 Introduction Congratulations, you have purchased one of the finest AIR-Ride Height Control Systems available. This system can: • use height sensors, pressure senders, or both height and pressure senders to monitor and control of all four corners of the vehicle with the option of monitoring the tank pressure. •...
-
Page 3: Operation / Programming
OPERATION / PROGRAMMING The auto height control system is active when both the large red power wire and the yellow accessory power wire are on. When the accessory power is off the display and height control will shut down to prevent draining the battery. - Page 4 Manual Control / Setup Switches SETUP UP SETUP SELECT SETUP DOWN Setup Menus: To enter the setup mode, press and hold the Setup Select Switch while turning the key on. Use the top and bottom Setup Switches to scroll up and down through the menus. Use the Setup Select switch to select a menu item.
- Page 5 Changing the output speed: The output speed can be used to slow down systems with large air lines or high pressure tanks so that the system will operate more reliably and stop at the desired height with minimal overshoot. 1. Begin with the key off and then hold the left Setup Select Switch in while turning the key on. The display will show (“CODE”...
-
Page 6: Service And Repair
Any action for breach of any warranty hereunder, including any implied warranty of merchantability, must be brought within a period of 24 months from date of original purchase. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.