Crown Boiler CWD060 User Manual

Gas-Fired, Direct Vent
Hot Water Boiler
DIMENSIONS ( in inches )
Air inlet collar located on center rear of CWD193 through CWD245
*

CWD SERIES SPECIFICATIONS

D.O.E
AGA
NO. OF HEATING
INPUT
Model
SECS. CAPACITY
BTU/HR
BTU/HR
CWD060 3 60,000 51,000
CWD083 4 82,500 71,000
CWD110 5 110,000 94,000
CWD138 6 137,500 118,000
CWD165 7 165,000 142,000
CWD193 8 192,500 165,000
CWD220 9 220,000 189,000
CWD245 10 245,000 211,000

LOCATING THE BOILER

• Clearances: Sides 1", front 3", rear 1", top 12"
• 6" clearance to air inlet collar when combustion air is supplied from indoors
• Boiler may be installed directly on a non-carpeted combustible floor
• Relief valve may not be moved from factory location
Important: This boiler requires a special venting system.
Read instructions carefully before installing.
Heat Exchanger constructed and tested in accordance
with ASME Section IV standard.
AVAILABLE FROM:
CROWN Co-axial Horizontal Vent Terminal
IBR NET COLLAR
WATER DIAMETER WIDTH
RATING A AFUE
INLET EXHAUST
BTU/HR.
(inches) (inches) (inches) (%)
44,000 4" 3" 16-1/8 85.1
62,000 4" 3" 19-3/4 85.1
82,000 4" 3" 23-3/8 85.2
103,000 4" 3" 27 85.2
123,000 4" 3" or 4" 30-5/8 85.2
143,000 4" 3" or 4" 34-1/8 85.2
164,000 4" 3" or 4" 32-3/4 85.2
183,000 4" 3" or 4" 41-3/8 85.3
1. Altitudes above 2,000 ft.–ratings should be reduced at a rate of 4%
for each 1,000 ft. above sea level (U.S.A. only), in Canada, boilers are
certified for altitudes up to 2,000 feet only.
2. Please specify fuel (natural gas or LPG).
3. Specifications and dimensions are subject to change without notice.
Since 1949, homeowners have depended on us
for quality, value and service
3633 I Street, P. O. Box 14818
Philadelphia, PA 19134
Phone: (215) 535-8900 Fax: (215) 535-9736
Visit us on the web: www.crownboiler.com
SHIPPING
WEIGHT
280
315
350
385
420
475
525
580
CWD-11/05-(20M)
PN980528R1