Advertisement
Quick Links
IMI CORNELIUS REMCOR INC g 500 REGENCY DRIVE g GLENDALE HEIGHTS, IL 60139--2268
Telephone (800) 551--4423
DRAIN LINE SUPPORT INSTALLATION INSTRUCTIONS
Read and understand these instructions thoroughly before installing this kit. Retain these instructions as part of
your equipment manual.
INSTALLATION PROCEDURE FOR FLAT FLOOR DRAINS
1. Mount the wire form support in the center of the floor drain
grid and clamp it' s four legs of the support onto the drain grid
securely. If necessary, reform the legs to fit and attach firmly to
the drain grid. The clamps are omitted for clarity on the first two
illustrations.
2. Place the plastic splashguard collar over the
wire form support.
3. The adjustable clamps will accomodate
1/2-- inch, 3/4--inch, and 1--inch I.D. either
soft or ridgid (hard) PVC tubing. Squeezing
the two tabs together that are located on
the clamp--locking collar will loosen a
tightened clamp.
E IMI Cornelius Inc; 1999
Facsimile (800) 519--4423
KIT P/N 629087401
Rev B
Revised: 12/22/99
November 4, 1999
620918801
Advertisement
Summary of Contents for Cornelius 629087401
- Page 1 IMI CORNELIUS REMCOR INC g 500 REGENCY DRIVE g GLENDALE HEIGHTS, IL 60139--2268 Telephone (800) 551--4423 Facsimile (800) 519--4423 KIT P/N 629087401 DRAIN LINE SUPPORT INSTALLATION INSTRUCTIONS Read and understand these instructions thoroughly before installing this kit. Retain these instructions as part of your equipment manual.
- Page 2 4. Place each drain line a minimum of 2--inches up from the wire form feet and tighten each clamp bolt in place to firmly secure the drin line(s) in place. The collar is omitted for clarity. 5. Check for kinks and eliminate them. If necessary, add appropriate size 45°barb to barb connectors.