Table of Contents
Advertisement
When using with a PC:
4. Plug the analog (or digital) video signal cable into the Analog (or Digital) Video Input
port on the back of the display ("ANALOG IN" (or "DIGITAL IN") as shown above).
5. Connect the other end of the video cable into your computer's video port. (Please check
your computer's documentation if you're not sure where the port is located.)
6. Connect the audio-mic cable (green) from "AUDIO1" port of the display to the line-out
port of your PC and connect other wire (red) from "MIC" port of the display to the line-in
port of your PC.
When using with AV devices (e.g., DVD/VCD-player,... etc.):
7. Plug the S-video signal (or CVBS) cable into the S-video (or CVBS) Input port on the
back of the display ("S-VIDEO" (or "CVBS") as shown above).
8. Connect the other end of the video cable into your AV devices S-video (or CVBS) output
port.
9. Connect the Two-wire audio cable from "AUDIO 2" port of the display to the audio
output port (white plug connect to the "AUDIO L" and red plug connect to the "AUDIO R")
of your AV device.
Note: For best display performance, it is strongly recommended that you use Auto
Setup to automatically configure your display's settings (only for Analog
input).
17
Advertisement
Table of Contents
