Mounting The System - Hitachi AX-M90 Instruction Manual

Desktop cd system

GENERAL OPERATION

M o u n t i n g t h e S y s t e m t o t h e w a l l

The supplied paper pattern helps you properly align the system.

1. Mark where to fasten the screws on the wall.

N o t e :

N o t e : Wall mounting screws are not supplied with this system. Use screws that are

N o t e :

suitable for the wall material and the hold size as illustrated here. (see fig 1)

2. Drive the screws into the wall, leaving about 1/2 inch extended.

3. Hang the system onto the protruding screws.

Ensure that the screws securely connect with the

narrow part of the holes.

N o t e :

•

The wall onto which the system is attached

should be capable of supporting 33lbs. per

screw.

•

Confirm that all screws are fastened tightly and

are properly fitted into the holes.

M o u n t i n g t h e S y s t e m t o I t s B a s e

1. Align the grooves on the underside of the unit with

the guides located on the base. See fig. 2.

2. Slide the unit onto the base.

3. Tighten the two screws underneath the

base to firmly hold the unit in place. See

fig. 3.

R e m o v i n g t h e S y s t e m f r o m I t s b a s e

1. Loosen the two screws underneath the

base.

2. Slide the unit from the base.

155mm

figure 1

4.5mm

20mm

3mm

fig. 2

fig. 3

Table of Contents

Show Quick Links