Canon LV-7297M User Manual page 57

Standby mode
This function is available when operating the
projector via network.
For LV-7292A, LV-7297A, LV-7392A,
LV-8227A:
Network .. Supply the power to the network
function even after turning off the
projector by pressing the POWER
button on the remote control unit.
Eco ......... Select Eco when you do not use
the projector via network. The
projector's network function will
stop when turning off the projector,
you can not turn on the projector
via network.
Refer to the user's manual of "Network Set-up
and Operation".
For LV-7292M, LV-7297M, LV-8227M:
Serial ...... Does not restrict functionality even
in standby mode.
Eco ......... Restricts some functions in
standby mode to reduce power
consumption.
P-timer
This function allows you to change the setting of
the P-timer and execute it.
Select one of the following options:
Count up ....... The P-timer display 000:00
appears on the screen and the
count up starts (000:00-180:00)
Count down .. The time set in the Timer setting
appears on the screen and the
countdown starts.
Timer ............. Use the Point ▲▼ buttons to set
the Timer (1-180 Min). Timer is
available in Count down only.
Factory default velue is 10 Min.
Start ............... It executes the count up or count
down function. Press the OK
button at Start and the indication
changes into Stop. To stop
Count up or Count down, press
the OK button at Stop on the
screen menu, then the indication
changes into Restart. Press the
OK button at Restart to resume
Count up or Count down.
Reset ............. Reset the P-timer values.
Press the OK button at Reset to
return to the following value;
Count up ... "000:00"
Count down ... Timer that
Exit ................ To exit the P-timer operation.
X: disabled
Serial command
Network*2
Audio Out
Direct power on
*1 When switch the STANDBY MIC OUT function On in
Standby mode status, only MIC volume can be output.
*2 Network is only for LV-7292A, LV-7297A, LV-7392A,
LV-8227A.
Note:
When selecting Network, the cooling fans may be
•
running depending on the temperature inside the
projector even if the projector is turned off.
• When Eco is selected and the projector is in
Standby mode, the communication of RS-232C
serial port is not available.
• Network is only for LV-7292A, LV-7297A,
LV-7392A, LV-8227A.
P-TIMER
P-timer display
you set
Stop or Cancel the P-timer via Remote control unit
To stop the P-timer function, press the P-TIMER button.
To cancel the P-timer, press and hold the P-TIMER
button for a few seconds.
O: enabled
Eco Network/Serial
X
X
X
O
Setting
O
O
X *1
O
57