Hitachi CP-S235W User Manual page 65

Lamp
Lamp
WARNING The projector uses a high-pressure mercury glass lamp made of
glass. The lamp can break with a loud bang, or burn out, if jolted or scratched,
handled while hot, or worn over time. Note that each lamp has a different lifetime, and
some may burst or burn out soon after you start using them. In addition, when the bulb
bursts, it is possible for shards of glass to fly into the lamp housing, and for gas
containing mercury to escape from the projector's vent holes.
About disposal of a lamp • This product contains a mercury lamp; do not put in trash.
Dispose of in accord with environmental laws.
For lamp recycling, go to www.lamprecycle.org. (in USA)
For product disposal, contact your local government agency or www.eiae.org (in the
US) or www.epsc.ca (in Canada).
For more information, call your dealer.
• Please carefully read the section "Lamp" of "User's Manual – Safety Guide".
• Do not open the lamp cover, if the projector is mounted on the ceiling, or if the lamp
has broken. Ask your dealer to replace the lamp.
• Before replacing the lamp, make sure the power switch is off and the power cable is
not plugged in, then wait at least 45 minutes for the lamp to cool sufficiently.
• Use the lamp of the specified type only. Type number: DT00621 (sold separately)
Do not use old (used) lamps; this is a cause of breakage.
CAUTION • Do not reset the lamp timer without replacing the lamp.
7