Coleman HOOLIGAN 2000001591 Manual

HOOLIGAN
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
tent into the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Pole Descriptions
Pole
Description Qty. Dia.
Main Pole, black 2 8.5mm 501000541
Vestibule Pole, grey 1 8.5mm 501000541
Vent Pole, black, short
with pre-bent ferrules 1 6.3mm 501000638
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the
door facing perpendicular to the wind direction. Unzip door.
2. Assemble Main Poles by interlocking the black, shock-cord-
ed, sections.
3. Insert Main Poles through sleeves in top of tent. (Fig. 1)
Back of Tent
Main
Sleeve
Pole
4. Insert one end of black Main Pole into pin on metal loop
located at either end of tent. (Fig. 2)
5. Go to opposite end of Main Pole and gradually apply pressure
to pole forming an arch. Insert pin into
the pole end (Fig. 2 & 3). Repeat for the
remaining Main Pole.
Stake
Fig. 3
6. Stretch out corners and sides of
tent. Drive in stakes at an angle
through the metal loops to help
anchor the corners & sides of the
tent. (Fig. 3 & 4)
4
TM
MODEL 2000001591
Pole Pole
Repair Kit Replacement Kit
501000547
501000547
501000638
Fig. 1
Door
Main
Pole
Sleeve
Main
Pole
Metal
Loop
& Pin
Fig. 2
Stake
Fig. 4
7. Assemble thin, black, shock-corded Vent Pole.
8. Insert Vent Pole through
sleeve at back of tent.
(Fig. 5)
9. Insert metal tip into
grommet. Go to opposite
end of Vent Pole and
gradually apply pressure
to pole forming an arch
then insert metal
tip into grommet.
(Fig. 6 & 6A)
6A
To Attach Rainfly
1. Drape Rainfly over tent. Make sure seams on Rainfly are
facing down and centered over poles and the vestibule is
over to door of the tent. (Fig. 7)
NOTE: Hook and loop fasteners, located on seams of under -
side of rainfly, should be centered over black poles.
2. Fold Rainfly at front of tent back as shown in Fig. 8.
3. Assemble Vestibule Pole by interlocking the grey, shock-
corded, sections.
4. Insert one end of grey Vestibule Pole into pin on metal loop
located at either side of tent. (Fig. 8 & 8A)
5. Go to opposite end of Vestibule Pole and gradually apply
pressure to pole forming an arch. Insert pin into the pole end
(Fig. 8 & 8A).
Hook & Loop
Fasteners
8A
(continued on other side)
Sleeve
Vent Pole
Back of Tent
Fig. 5
Fig. 6
Rainfly
Vestibule
over Door
Front
of Tent
Fig. 7
Grey Vestibule Pole
Door
Front of
Tent
Fig. 8