Table of Contents
Advertisement
2.
INSTALLING YOUR VIDEO RECORDER
Initial installation
1
Press
on the remote control.
MENU
The automatic TV channel search starts.
2
Wait until all the TV channels have been found. This can
take several minutes.
3
When all TV channels have been found, 'OK' will briefly
appear in the video recorder display.
•
Next, the year, for instance, '2000' will appear in the video
recorder display. Change it if required with the number
buttons
on the remote control.
0-9
4
Confirm with
.
OK
5
If required, change the month, for instance 'M 01' in the
same way.
6
Confirm with
.
OK
7
If required, change the date, for instance, 'D 01' in the
same way.
8
Confirm with
.
OK
9
If required, change the time, for instance, '20:00' in the
same way.
0
Confirm with
.
OK
'OK' will briefly flash in the video recorder display.
The initial installation is now complete.
Note: In the section 'satellite receiver' you can find
information about how to connect a satellite receiver.
Manual TV channel search
In certain cases the 'Automatic TV channel search' may not be
able to find all of the TV channels (e.g. coded TV channels). In
that case, use this manual method to set the channels.
1
Switch on the TV set. If required, select the programme
number for the video recorder.
2
Press
on the remote control. 'CLK' will appear in
MENU
the video recorder display.
2000
3
Select 'MAN' (manual search) with
4
Confirm with
.
OK
5
Select the desired programme number, for instance,
'P01' with
or
P- =
;P+
6
Confirm with
.
OK
'CH' will flash in the video recorder display.
7
Enter the channel of the desired TV channel with the
number buttons
.
0-9
Note: If you don't know the channel of the desired TV
channel, hold
to start the automatic search.
;P+
Repeat the automatic search until have found the desired
TV channel. A changing channel number will appear in the
video recorder display.
8
Press
until 'OK' appears in the display.
OK
Note: If you want to search for further TV channels, start
4
again at step
.
9
To end, press
.
MENU
Satellite receiver
You can receive channels from the satellite receiver via the
scart socket
.
AV1 EXT1
To do this, select the channel number 'E1' with
remote control. You should select the channels to be received
by the satellite receiver on the receiver itself.
Special installation functions
You can select one of the following installation functions in
order to adapt the video recorder to your own specific
requirements.
Automatic TV channel search
The video recorder will search for all TV channels.
Note: If you want to start the automatic TV channel search
again, then follow the instructions below.
1
Switch on the TV set. If required, select the programme
number for the video recorder.
2
Press
on the remote control. 'CLK' will appear in
MENU
the video recorder display.
or
.
;P+
P- =
and confirm with
.
OK
on the
0
5
Advertisement
Table of Contents
