Table of Contents
Advertisement
Replacing a Boot HBA
EMC Symmetrix
EMC CLARiiON
If a boot HBA fails, you can replace it with a new one as described in
this section.
Follow the procedure under Configuring a Symmetrix Boot Device.
Shut down and power off the server.
Replace the HBA in the identical location and reconnect cabling.
(Fabric configuration only) Repeat the procedure under Preparing
the Fabric on page 3-15, and replace the old HBA's WWPN with
the new HBA's WWPN.
Repeat the procedure under Verifying HBA Driver and Digital
Signature Installation on page 3-25.
Configuring an EMC Boot Device
Replacing a Boot HBA
3
3-33
Advertisement
Table of Contents
