Table of Contents
Advertisement
Power
230VAC, Single Phase, 60 Hz, 60
Requirement
Amps
Secondary
8.8V - 9.5V
No Load
Voltage
Timed Work
Timed Range: 0 - 1.2 sec.
Mode
Included
(6) Electrode Tips, Slide-pull Ham-
Accessories
mer, (2) Hook Tips, (3) Carbon Rods
Dimensions
17"L x 11"W x 11"H
You will need the manual for the safety warnings and precautions, assembly instructions, operating and
maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice num-
ber on the inside of the front cover. Keep the manual and invoice in a safe and dry place for future reference.
General Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to reduce the
risk of personal injury and damage to equipment.
1.
Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such as in the presence of flam-
2
mable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
3.
Keep bystanders, children, and visitors away while operating a power tool. Distractions
can cause you to lose control. Protect others in the work area from debris such as chips and sparks.
Provide barriers or shields as needed.
Grounded tools must be plugged into an outlet properly installed and grounded in accor-
4.
dance with all codes and ordinances. Never remove the grounding prong or modify the plug
in any way. Do not use any adapter plugs. Check with a qualified electrician if you are in
doubt whether the outlet is properly grounded. If the tool should electrically malfunction or break
down, grounding provides a low resistance path to carry electricity away from the user.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrigera-
5.
tors. There is an increased risk of electric shock if your body is grounded.
6.
Do not expose power tools to rain or wet conditions. Water entering a power tool will increase
the risk of electric shock.
7.
Do not abuse the Power Cord. Never use the Power Cord to carry the tool or pull the Plug
from an outlet. Keep the Power Cord away from heat, oil, sharp edges, or moving parts.
Replace damaged Power Cords immediately. Damaged Power Cords increase the risk of electric
shock.
SKU 94739
Specifications
Save This Manual
Read all instructions before using this tool!
Work Area Safety
Electrical Safety
For technical questions, please call 1-800-444-3353
Max Power
10KVA
(Instant)
Max. Working
1300 A
Current
(Instant)
Required
3-Prong, 230 VAC, Polarized, Twist Lock, 60
Electrical
Amps for maximum output (not included)
Plug
Duty Cycle
15% Spot Welding at Max. Output Power
40% Carbon Warming at Min. Output Power
Net Weight
63 Lbs.
Page 2
Advertisement
Table of Contents
