Specifications - Mark Levinson 390S Owner's Manual

Frequency Response
Total Harmonic Distortion
Dynamic Range
Signal-to-Noise Ratio
Channel Separation
Intermodulation Distortion
(SMPTE IMD)
Maximum Output
(0 dBFS signal)
Volume Control
(attenuation) Range
Digital-to-Analog
Conversion
Conversion Rate
Analog Filter
Low-level Linearity
Output Impedance (analog)
Direct Digital Output, XLR
Direct Digital Output, RCA
Mains Voltage
Mains Frequency
Power Consumption
Overall Dimensions
Shipping Weight
Input Complement

Specifications

The correlation between published specifications and sonic quality is
unreliable. A list of numbers reveals virtually nothing. All technical
measurements must be subject to qualitative as well as quantitative
interpretation.
Measurements of the Nº390S yield excellent results by any standards.
However, only those specifications that apply to its actual operation are
included here.
10Hz - 20kHz, +0dB, –0.3dB
•
0.002% @ 1 kHz, 0dBFS (10Hz-30kHz)
•
(THD)
96dB (10Hz-30kHz)
•
105dB (10Hz-30kHz)
•
Better than 110 Db
•
Less than 0.005%
•
4.45V balanced
•
2.225V single-ended
•
–61.2 to +12 dB
•
Dual differential 24-bit DACs
•
352.8kHz or 384kHz(input signal dependent), 24-bit
•
Bessel-tuned, linear phase to 40kHz
•
deviation less than 2 dB to below –90Dbfs less than 2 dB to
•
below –102dBFS w/20-bit input
10
•
AES/EBU 110 , 3.5V
•
S/PDIF 75 , 0.5V
•
100V, 120V, 200V, 220V, 240V, factory set for destination country
•
50 or 60 Hz, factory set for destination country
•
36 watts maximum
•
See "Dimensions"
•
50 lbs. (23 kg)
•
1 EIAJ digital input
•
1 S/PDIF (RCA) digital input
•
59