Summary of Contents for Mark Feldstein & Associates SP4080
- Page 1 SP4080 Wireless Stereo 863MHz Speaker System User’s Manual Please read before using the equipment...
-
Page 2: Package Includes
INTRODUCTION This 863 MHz stereo wireless speaker system uses latest wireless technology that enables you to enjoy music and TV sound anywhere inside or outside your home. You can simply connect the system to any audio source such as Radio, TV, VCR, Hi-Fi and iPod/CD/MP3/VCD/DVD player. - Page 3 COMPONENT IDENTIFICATION TRANSMITTER SPEAKER RECEIVERS 1. Power LED Indicator 2. Signal LED Indicator 3. Audio In 4. Channel Selector 5. DC In (8V) 6. Battery Compartment 7. Volume Down 8. Power/Signal LED Indicator 9. Volume Up 10. Boost Bass 11. Auto Scan 12.
- Page 4 INSTALLATION TRANSMITTER Plug the supplied 8V AC/DC power adaptor in the DC jack located on the rear of the transmitter. Connect the supplied 8V AC/DC power adaptor to an electrical wall outlet. The Power LED then glows. The transmitter can be connected to audio output jack of TV, Monitor, VCR, Radio, CD, MP3, VCD or DVD players with the cables provided.
-
Page 5: Operation
OPERATION Turn on the audio source to which the transmitter is connected with. The Signal LED on transmitter will light up. Select a channel of the transmitter for best performance in your location. Select the L/M/R (Left/Mono/Right) selector under the speakers, one to L and the other to R for the best stereo reception. - Page 6 Signal LED on the Transmitter would be cut off automatically if there is no/weak operation input signal from audio source for 4 minutes. When the signal comes back, the transmitter will work again automatically. NOTE : You should now be able to place the speakers freely from room to room without disruption.
- Page 7 TROUBLE SHOOTING NO SOUND Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on the transmitter. Ensure the speaker is switch ON. Speaker’s battery capacity is too low, replace with new batteries or connect the AC adaptors to the speakers.
-
Page 8: Technical Specifications
TECHNICAL SPECIFICATIONS Transmission Mode : UHF stereo Carrier Frequency : 863 MHz Operation Voltage : Transmitter, AC/DC 8V 200mA Power Adaptor Speaker, 6 X ‘AA’ size Alkaline Batteries or AC/DC 9V 1.2A Power Adaptor Frequency Response : 40Hz – 12KHz Distortion : 1.5% S/N Ratio...