Water Connection - Hotpoint Ultima Digit Instructions For Installation And Use Manual

!
!

Water connection

Connecting the water inlet hose supplied.
Remember that this is a cold-fill machine and the
water inlet hose MUST be fitted to the rear of the
machine and the cold water supply.
Please use the new hose supplied (located inside
the drum). Old hoses may cause leaks due to worn
out washers or may split due to water pressure.
- Before making the connections to the cold water
supply, allow the water to run freely from the cold
water supply tap until it is perfectly clear.
- Connect the straight end of the hose to the cold
water supply tap until tight.
- Connect the angled end of the
hose to the washing machine's
cold water inlet point, situated
at the top right hand side on
the rear of the appliance (see
figure).
Turn the cold water supply tap on and check for leaks:
tighten if necessary.
!
!
!
!
!
!
!