Before Switching On Your Tv; Power Connection; Connections To The Rf Input Socket; How To Connect Other Devices - Hitachi 20LD2500 Instructions For Use Manual

Before Switching On Your TV

Power Connection

AC adapter
IMPORTANT: The TV set is designed to op-
erate on 12 V DC. For this, an adaptor is
used which gives 12V DC voltage. Connect
this adaptor to a system that supplies 220-
240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The RF Input
Socket
75
VHF/UHF
REAR OF THE TV
• Connect the aerial or cable TV plug to the
RF input socket located at the rear of the TV
and connect the cable plug coming out from
the TV out socket located on the devices
(VCR, DVB etc.) to this socket as well.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
rear side of the TV.For connection of other
devices via SCART refer to the manuals of
the related devices.
To POWER
INPUT DC 12 V
terminal
CABLE TV
Inserting Batteries In The Remote
Control Handset
• Remove the battery cover located on the
back of the handset by gently pulling up-
wards from the indicated part.
• Insert two AAA (R03) or equivalent type of
batteries inside.
• Replace the battery cover.
NOTE: Remove the batteries from remote
control handset when it is not to be used for
a long period.Otherwise it can be damaged
due to any leakage of batteries.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-
tem. Press the "
of the TV. Then the TV switches itself to
stand-by mode and the led becomes red
located on the front of the TV.
2- To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press the "-P/CH" or "P/CH+"button on the
right side of the TV or press the "-P/CH" or
"P/CH+" button on the remote control, so that
the last programme switched off is selected.
Either way the TV will switch on and the LED
becomes green.
- 9 -
" button on the right side