Network Settings - Hitachi WNM80 User Manual

Network Settings

This section explains how to do wireless presentations (Live Mode), how to do presentation
playback (Playback Mode) and how to use your Web browser to access the remote control panel.
If your PC is not ready for 802.11b wireless LAN communication, purchase an 802.11b wireless
LAN card and install the device driver. (Refer to the corresponding PC and/or LAN card user
guide for details.)
<Preparations> (set the PC and the module to the same configurations)
• Configure the PC and WNM80 module for wireless communications. Insert the wireless LAN
cards into both the PC and WNM80 module and enable wireless LAN communications.
NOTE
If the PC is already equipped with a built-in 802.11b wireless LAN card, you don't need to
insert a new wireless LAN card.
• Next, configure as shown in the following table:
(1) Wireless Settings for the WNM80 Module
• Slowly and carefully insert the accompanying wireless LAN card into the WNM80 module's PC
card slot. Be careful not to insert the card too hard as you may bend the connector pins.
• Turn on the power of the projector (that the WNM80 module is mounted to) and then press the
STANDBY button to turn on the lamp.
• As explained in the Introduction section of this user guide, bring up the projector's WIRELESS menu and
configure the network settings as necessary. Refer to
(2) Wireless Settings for the PC
PCs with a built-in wireless LAN card
Enable the built-in wireless LAN communications of the PC.
Refer to your PC user guide for details. Continue on
network settings.
PCs using PCMCIA wireless LAN card
If you are using a new wireless LAN card, follow the instructions in the corresponding wireless
LAN card user guide to install the card's dedicated driver into your PC.
Insert the wireless LAN card into your PC's card slot.
Continue on
NOTE
Consult with your network administrator if there is already a connection to the network
for information on how to configure network settings.
for information on the network configuration method.
for information on how to configure