Hitachi PJ-LC5 User Manual page 59

WARNING • Please use extra caution when connecting the power cord as incorrect or faulty
connections may result in FIRE and/or ELECTRICAL SHOCK. Please adhere to the "User's manual –
Safety Guide" and the following.
• Only plug the power cord into outlets rated for use with the power cord's specified voltage range.
• Only use the power cord that came with the projector. If it is damaged, contact your dealer to newly get
correct one.
• Never modify the power cord. Never attempt to defeat the ground connection of the three-pronged plug.
• Make sure that you firmly connect the power cord to the projector and wall outlet.
Connect the connector of the power cord to the AC
1
inlet of the projector.
Firmly plug the power cord's plug into the outlet.
2
WARNING • When the power is ON, a stronglight is emitted. Do not look into the lens or vents of
the projector.
Remove the lens cap.
1
Set the power switch to [ | ] (ON).
2
Power switch (ON position)
The POWER indicator will light orange.
Press the STANDBY/ON button of the
3
projector or the
control.
The projector lamp will light up and the
POWER indicator will begin blinking green.
According to a setup, the projector lamp
may light up and the POWER indicator
may begin blinking green, without
pressing this button.
When the power is completely on, the
indicator will stop blinking and light green.
POWER indicator
TEMP
POWER
STANDBY/ON INPUT
MENU
STANDBY/ON button
button of the remote
LAMP
Power switch
AC Inlet
Press the STANDBY/ON button of the
1
projector or the
control.
The message "Power off?" will appear on
the screen for approximately 5 seconds.
Press the STANDBY/ON button again
2
while "Power off?" the message is
visible.
The projector lamp will go off, and the
POWER indicator will begin blanking orange.
Then the POWER indicator will stop
blinking and light to solid orange when the
lamp cooling is complete.
Switch the power switch to [O] (OFF).
3
Power switch (OFF position)
The POWER indicator will go off.
Attached the lens cap.
4
Connector Side
button of the remote
3