Advertisement

Quick Links

www.moffatappliances.ca
. . . . . . . . . . . 2
Owner's Manual and
Installation Instructions
Operating/Care and
Cleaning Instructions
TV337*-Vent options only
Charcoal Filter . . . . . . . . . . . . . . .4
Grease Filter . . . . . . . . . . . . . . . . .3
Hood Light . . . . . . . . . . . . . . . . . .4
Hood Surfaces . . . . . . . . . . . . . . . .4
Controls . . . . . . . . . . . . . . . . . . . . .3
. . .5-13
Consumer Support
Consumer Support . . .Back Cover
Warranty . . . . . . . . . . . . . . . . . . . 14
*
Write the model and serial numbers here:
Model # __________________________
Serial # __________________________
You can find them on a label on the
back wall of the hood.
350A4502P5661 29-5641 03-08 ATS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TV337 and is the answer not in the manual?

Questions and answers

Summary of Contents for Moffat TV337

  • Page 1: Table Of Contents

    www.moffatappliances.ca Safety Information ... 2 Owner’s Manual and Installation Instructions Operating/Care and Cleaning Instructions TV337*–Vent options only Charcoal Filter ....4 Grease Filter .
  • Page 2: Important Safety Information

    IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS WARNING – WARNING – TO REDUCE THE RISK OF FIRE, TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE A RANGE TOP GREASE FIRE: THE FOLLOWING: A. Never leave surface units unattended at high A.
  • Page 3: Grease Filter

    Using the hood controls. Throughout this manual, features and appearance may vary from your model. Switch Pad Controls Control Knobs (on some models) (on some models) NITE FAN Control LIGHT Control Turn to HI , MED or LO as needed. Press the pad at the top to turn the light ON .
  • Page 4: Charcoal Filter

    Charcoal Filter—Recirculating Installations Only The charcoal filter cannot be cleaned. To remove: It must be replaced. Order filter no. Pull down on the center of the front WB02X10700. Replacement filters edge of the filter. The filter will then can be ordered from your GE supplier. slip out of the retaining tabs on the back.
  • Page 5: Installation Instructions

    Range Hood Installation Instructions Questions? Call 1-800-561-3344 www.moffatappliances.ca or Visit our Website at: BEFORE YOU BEGIN DUCTWORK REQUIREMENTS** NOTE: Read the ductwork sections only if you do not Read these instructions completely and carefully. have existing ductwork. If you have existing ductwork, IMPORTANT –...
  • Page 6 Installation Instructions WORKSHEET—CALCULATE TOTAL EQUIVALENT DUCTWORK LENGTH* DUCT EQUIVALENT NUMBER DUCT EQUIVALENT NUMBER PIECES LENGTH x USED = TOTAL PIECES LENGTH x USED = TOTAL 3¼” x 10” 1 Ft. 6” Round 24 Ft. Rect., wall cap (18 ft. w/o straight with damper)
  • Page 7: Parts Included

    Installation Instructions DAMAGE – SHIPMENT/INSTALLATION TOOLS YOU WILL NEED • If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement. • If the unit is damaged by the customer, repair or Flat blade and Phillips Pencil replacement is the responsibility of the customer.
  • Page 8 Installation Instructions CHOOSE VENT OPTION Determine the vent option that your installation will IMPORTANT: If the hood is to be installed in a require and that is available for your model from the recirculating, non-vented ductless manner, do not below choices. knock out any vent openings in the hood.
  • Page 9 Installation Instructions REMOVE EXHAUST ADAPTOR* REMOVE WIRING KNOCKOUT If exhausting/venting using the 3¼” x 10” rectangular Remove either the top or the back wiring knockout as duct needed and install an approved strain relief clamp. Remove the exhaust adaptor from the inside of the Back knockout Top knockout hood.
  • Page 10 Installation Instructions MARK HOLES* FOR 7” ROUND VERTICAL Select the vent option that your installation will DUCTED DISCHARGE require and proceed to that section: INSTALLATIONS ONLY:* A.Outside top exhaust Bend up the duct alignment ears in preparation for ” ” later attachment of the 7”...
  • Page 11 Installation Instructions C.Outside rear exhaust SCREW IN PARTWAY ” ” (Horizontal duct–3¼ x 10 Rectangular) Drive a mounting screw (from the hardware packet) partway into each center of the narrow neck of the • Use the diagram or the hood as a template and keyhole slots marked on the cabinet bottom.
  • Page 12: Connect Wiring

    Installation Instructions INSTALL LIGHT BULB SECURE HOOD NOTE: A light bulb is not shipped with the hood. Slide the hood back against the wall. Tighten Obtain one locally. Purchase and install an ordinary the mounting screws. Be sure the screw heads screw-base light bulb, not more than 60 watts.
  • Page 13: Troubleshooting Checklist

    Installation Instructions REPLACE WIRING COVER TROUBLESHOOTING CHECKLIST If the hood seems to be operating at high speed when the control is not set on high, or if ventilation seems inadequate, check the following: ❏ Knockouts not removed from hood. ❏ Damper blade not opening. ❏...
  • Page 14: Range Hood Warranty

    Range Hood Warranty All warranty service provided by our Factory Service Centers, or Staple your receipt here. an authorized Customer Care technician. To schedule service, ® Proof of the original purchase on-line, 24 hours a day, visit us at GEAppliances.ca, or call date is needed to obtain service 1-800-561-3344.
  • Page 15: Consumer Support

    Moffat Appliances Website www.moffatappliances.ca Have a question or need assistance with your appliance? Try the Moffat Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals, order parts or even schedule service on-line.

Table of Contents