Download Print this page

Escort SRX Corvette C-6 Installation Tips Manual page 4

Radar & laser defense system

Advertisement

Front Laser Shifters: The Front Laser
Shifters (Code letter B on the
installation manual) can be mounted
different ways. They can be mounted
inside the grill area as on the
Yellow Z06 with the supplied mount
brackets and 3M Scotch VHB
sided tape (follow surface preparation
and temperature instructions for the
VHB tape),
Front Radar Receiver: The Front Radar Receiver (Code letter A on the installation manual)
can be mounted inside the grill area using self taping hardware. Place the unit in the middle
and screw it to the plastic shroud. The unit can also be mounted inside under the hood
using double side tape and placed on the small ledge on the driver side as along as no
metallic parts obstruct the view forward (tip: do not mount radar receiver behind license
plate). The ledge is located behind the bumper.
Penetrating the Firewall: The wires from both front
shifters and the radar receiver should be run towards
the passenger side. The main wiring harness going
into the firewall will have a soft rubber boot around it.
You will need to disconnect and remove the battery
except on the Z06.
Take a small sharpened 1/8 inch metal rod and poke three holes through the rubber boot.
Cut the phone jack connectors off the wires and run thru the holes in the rubber
3M VHB (Very High Bond) tape 4979F Black, 1 inch x 36 yard 62.0 mil. thick. Conformable foam, multi-purpose acrylic
1
adhesive, black, clear PE film liner, double sided. VHB tape can be ordered through any automotive paint supple outlet that
carries 3M automotive products.
double
1
or they can be mounted outside the grill using
VHB double sided tape as shown on the black
car. Spread the shifters as far apart as possible
but maintain a clear view of the road ahead. The
shifters should be mounted as level as possible
(use the sight line on the short side of the shifter
as a level line) with the bubble lens on the top of
the front face. Remove the protective film from
the front face after installation. Feed the wires
towards the passenger side of the car under the
hood.
boot.

Advertisement

loading