Escient FireBall SE-500i Quick Setup

1. UNPACK YOUR NEW FIREBALL™ SEi
• Unpack the FireBall, cables, and accessories (save the box).
• Make note of the serial number (located on the back).
SERIAL NUMBER: _________________________________________
2. CONNECT FIREBALL TO YOUR A/V SYSTEM
• Locate the included composite video and analog audio cables.
• Connect FireBall to any available A/V input on your receiver or Telly.
Note: You may use optional s-video or component video cables and optional digital audio cables
for the best picture and sound quality
Note: The default video output mode is NTSC. Instructions for changing the video mode to PAL are
in the User's Guide.
3. CONNECT FIREBALL TO THE INTERNET
FireBall requires an Internet connection to identify the CDs played and recorded in the front panel
drive, for playing Internet Radio stations, and for general system maintenance.
• Connect the included ethernet cable from
FireBall's ethernet jack to your ethernet
network.
NOTE: You may need to purchase additional
network hardware such as a "router".
Please contact your Escient dealer for more
information.
©2007 Escient. All rights reserved. Escient and the Escient logo are registered
trademarks and FireBall and Physital are trademarks of Digital Networks North
America, Inc. All other trademarks are property of their respective owners.
Escient reserves the right to change product hardware, features and software
without notice. Upon any change, materials are updated as quickly as
possible, but may not be reflected in documents already distributed.
Supported hardware is updated continually. If you wish to interface with
hardware that is not listed on this data sheet, please call Escient at
800.372.4368.
Quick Setup
IR In for IR external control
Power to electrical outlet
4. POWER UP!
• Plug FireBall into an AC outlet.
• The Standby LED on the front of the FireBall will begin to flash RED during the power on cycle.
When the LED turns solid RED, the FireBall is ready for use.
• Press the power button on the front panel or on the remote control.
The LED will turn solid BLUE and video will be displayed on the Telly when the unit is on.
Note: You may have to press the "FB1" button on the remote to configure it to control FireBall. Also
be sure the Telly and receiver are turned on and set to the correct FireBall input.

5. QUICK START

• Use the remote control and follow the on-screen instructions.
Composite or S-Video
Video Out to the Telly or
other display device
Component Video Out
Optical Out to the
to the Telly or other
receiver for digital audio
display device
Analog In from external
analog audio source
Analog Out to the
receiver for analog audio
6640 Intech Blvd.
Indianapolis, Indiana 46278, USA
www.escient.com
Email: support@escient.com
Document Number: M32004-03A1
Feb. 2007
RS-232 for external
control or touch screen
Note: 2nd COM Port only
available on SE-500i
Ethernet Network Jack
connects FireBall to your
broadband Ethernet
network.