Specifications Pump: 1/2 GPM Output Overall Dimensions: 18” x 13-1/2” x 9” Flexible Spot: 13-3/4” Motor: 110 Volt, Single Phase Shipping Weight: 18 lbs. Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram.
Page 3
Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines. 10. Maintain tools with care. Keep tools sharp and clean for better and safer performance. Follow instructions for lubricating and changing accessories. Inspect tool cords periodi- cally and, if damaged, have them repaired by an authorized technician.
Grounding and Voltage Warning Common household current is 110-120 volts. As long as your tool is rated from 110-120V, there will not be any complications using this tool with household receptacles. Never try to plug a 110-120V tool into a 220-240V circuit (or visa-versa) or serious complications and possible injury to the operator may occur.
Page 5
Assembly 1. The Handle for the Lid (#4) needs to be assembled. Remove nuts and washers from Handle. Place Handle in place on front portion of Lid and tighten screws with washers and nuts. 2. Attach the black plastic Filter to the Pump (#28). It fits over the wide opening on the side of the Pump. 3.
Operation (continued) 2. Do not run the Pump when small parts are in the bottom of the tank. 3. Never run the Pump without the Filter being in place. 4. Never leave the Pump running unattended. 5. Fill the Body with the water/household detergent solution. Before attempting to wash any parts, test the Parts Washer by plugging in the electrical plug and turning “ON”...
Need help?
Do you have a question about the 38347 and is the answer not in the manual?
Questions and answers