Table Of Contents - Duerkopp Adler 4280i-6 Instructions For Service Manual

CONTENTS:
.......................................................................................................................................................................... 1
.. 3.1.1 Description
3.1.2 Height setting of the hook
3.1.3 Setting the distance of the hook from the needle
3.1.4 Angular setting of the hook (timing)
3.1.5 Protection of the needle and of the hook point
3.1.6 Setting of the bobbin case opener
3.1.7 Setting the regulation of the hook lubrication
3.1.8 Replacement of the hook
3.1.9 Setting the gear
3.1.10 Dismantling of the hook post
3.2.1 Description
3.2.2 To check the handwheel angular adjustment
3.2.3 Height setting of the needle bar
3.2.4 Angular setting of the pin of the thread mechanism
3.2.5 Side setting of the needle bar holder
3.2.6
3.3.1 Description
3.3.2 Side setting of the throat plate post and setting of the needle bed shifting
3.4.1 Description
3.4.2 Setting the front guide
3.4.3 Setting the rear guide
3.4.4 Setting the guide of the needles (stitch widths with needles, side by side)
3.5.1 Description
3.5.2 Setting the tension of main and auxiliary tensioners
3.5.3 Setting the tensioning mechanisms of the main tensioners
3.5.4 Setting the adapting spring
3.5.5 Setting the thread limiter
3.6.1 Description
3.6.2 Stitch length mechanism
3.6.2.1
3.6.2.2
3.6.2.3 a Forward and rearward stitch length distribution (rough)
3.6.2.3 b Forward and rearward stitch length distribution (fine)
3.6.2.4
3.6.3 Lower feed wheel
3.6.3.1
3.6.3.2
3.6.4 Setting the top roller (pressing force, height)
3.7.1 Description
3.7.2 Side setting of the indented lower pulley
3.7.3 Side setting of the indented upper pulley
3.7.4 Setting the tensioning roller
............................................................................................................................................... 1
.............................................................................................................................................. 2
................................................................................................................................................................ 2
................................................................................................................................. 5
........................................................................................................................................................ 7
......................................................................................................................................... 7
............................................................................................................................................... 9
Setting the upper eccentric
Setting the prop
Setting of the control knob (including the stitch length limitation)
Feeding clutches
3.6.3.1.1 Description
3.6.3.1.2 Setting the lever of the second step of feeding(angle, position)
3.6.3.1.3 Setting of the lower eccentric
3.6.3.1.4 Setting the engagement and disengagement of the clutches
Wheel feeder and its post
3.6.3.2.1 Height setting of the feeder and tensioning of the chain
3.6.3.2.2 Replacement of the feeder
................................................................................................................................16
........................................................................ 11