Summary of Contents for EMP Tek VT-40.2
- Page 1 INTEGRATED HYBRID TUBE AMPLIFIER VT-40.2 Model HYBRID TUBE AMPLIFIER OW N ER’S M A N UA L...
-
Page 2: Safety Instructions
1. Do not open the amplifier, attempt any modifications or repairs. There are extremely high voltages present and any servicing must be referred to EMP Tek or an authorized qualified technician. 2. Opening the amplifier will void the warranty. -
Page 3: Maintenance And Cleaning
VT-40.2 Integrated Tube Amplifier Front View Back View Maintenance and Cleaning To maintain the amplifier's appearance, it is recommended use of a dry or slightly- damp soft cloth to keep the exterior of the amplifier free from dust, lint or dirt. When cleaning the amplifier, make sure the amplifier is turned off. -
Page 4: Vacuum Tubes
4. Insert a new set of tubes using a glove or dry cloth. NOTE: New tubes can be purchased from EMP Tek at www.emptek.com Features • Classic tube pre-amplifier design principals reduce odd-order harmonic distortion. -
Page 5: Amplifier Location
Amplifier Location Choose a location where air can circulate freely around the amplifier. Do not cover the amplifier. Attaching Speaker Wires When using a banana jack to attach speaker wires to the binding post terminals, loosen the top as shown in step 1, and then insert the speaker wire into the banana jack as shown in step 2. -
Page 6: Using The Amplifier
Using the Amplifier FRONT AND TOP PANELS Power: The power on/off switch is located on the front face of the amplifier. Volume: The volume can be adjusted using the knob on the top of the amplifier. Make sure the volume is set at a low setting when initially setting up the amplifier. Mode: Using the Mode knob on the top of the amplifier you can select from either AUX, MP3 or CD/DVD inputs. -
Page 7: Back Panel
Using the Amplifier (continued) BACK PANEL Variable Line Out: Headphones or to another amplifier or powered subwoofer AUX: Stereo input for any device with line out iPod/MP3: Stereo input for an iPod or MP3 player Input: Stereo input for a CD/DVD or any device with a low-level stereo line out BACK VIEW... -
Page 8: Specifications
Specifications Model VT-40.2 Amplifier Type: Integrated Tube Hybrid AC Input: 110V±10%/60Hz Power Output: 40 Watts Per Channel @ 8 Ohms 60 Watts Per Channel @ 4 Ohms Frequency Response: 20Hz–20kHz Distortion (THD): <2% S/N Ratio >80dB Pass Band: 10Hz–100kHz Signal Input (Analog): –... -
Page 9: Troubleshooting
THERE ARE NO USER SERVICEABLE PARTS INSIDE THE AMPLIFIER. If you cannot identify the cause of the problem using the chart, and are in need of repair, return the amplifier to an EMP Tek authorized service facility. Situation Probable Cause... -
Page 10: Warranty
EMP Tek, along with the original sales invoice or other proof of purchase, which establishes eligibility for warranty service. EMP Tek will, at its option, replace or repair the product free of charge and return the product by prepaid delivery. - Page 12 382 Marshall Way, Layton, Utah • USA • 84041 Toll Free: (801) 991-1308 • Fax: (801) 543-3300 www.emptek.com It is EMP Tek policy to continuously incorporate improvements into products; all specifications are subject to change without notice. Copyright © 2010 EMP Tek. All Rights Reserved.
Need help?
Do you have a question about the VT-40.2 and is the answer not in the manual?
Questions and answers