Fusion ENCOUNTER EN-SW100 Instruction Manual

ENCOUNTER
SUBWOOFERS
EN-SW100, EN-SW120, EN-SW150
Subwoofer Parameters
Max Power Rating
RMS Power Rating
Frequency Response
Impedance
Sensitivity
Mounting Depth
Mounting Diameter
Installation Guidelines
Ensure the audio system is turned off before making any connections to the amplifier, subwoofer or source unit.
Failure to do so could result in permanent damage to the audio system.
When wiring the subwoofer ensure that the wire is protected from sharp objects and always use rubber grommets
when wiring through metal panels. Ensure all terminals and connections are protected from the vehicle chassis and
from each other as failure to do so could result in permanent damage to the audio system.
When connecting the amplifier and subwoofer ensure you connect the positive and negative output wire from the
amplifier to the corresponding subwoofer terminals.
1) Ensure there is adequate clearance and depth for the subwoofer to be mounted
2) Use the supplied ruler to mark out and cut the correct diameter hole
3) Drill the holes for the mounting screws
4) Insert the subwoofer and affix with the appropriate screws (not included)
Optimum Enclosures
Ported
Volume (litres)
Volume (cu.ft.)
Port diameter
Port length
Tuned frequency (Hz)
Sealed
Volume (litres)
Volume (cu.ft.)
Tuned frequency (Hz)
EN-SW100 EN-SW120
300 Watts 400 Watts
150 Watts 200 Watts
24Hz - 3.5kHz 21Hz - 3kHz
4 Ohms 4 Ohms
88 dB 89 dB
120mm (4- ") 136mm (5-
3/4
226mm (8 - 275mm (10-
7/8")
EN-SW100 EN-SW120
28.5
1.008
76.2mm / 3" 76.2mm / 3"
255mm / 10" 225.3mm / 8 -
41.6
15.71
0.56
69.9
EN-SW150
500 Watts
250 Watts
20Hz - 2.5kHz
4 Ohms
90 dB
") 153mm (6")
3/8
349mm (13 -
13/16")
EN-SW150
48.28
1.705
101.6mm / 4"
" 242.5mm / 9 -
9 /10
33.0
28.58
1.009
53.9
3/4")
91.28
3.223
"
1/2
34.2
85.53
3.02
44.4