Fusion CS-SW100 Instruction Manual

SUBWOOFERS
CS-SW100 CS-SW120
SPEAKER PARAMETERS
Peak Power (Watts)
Rated Power (Watts)
Frequency Response
Impedance
Sensitivity
Cone Material
Voice Coil Type
Mounting Depth
Mounting Diameter
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the amplifier, speakers or source unit.
Failure to do so could result in permanent damage to the audio system.
When wiring the subwoofer ensure that the wire is protected from sharp objects and always use rubber
grommets when wiring through metal panels. Ensure all terminals and connections are protected from the
vehicle chassis and from each other as failure to do so could result in permanent damage to the audio system.
When connecting the amplifier and subwoofer ensure you connect the positive and negative output wire from
the amplifier to the corresponding subwoofer terminals.
1) Ensure there is adequate clearance and depth for the subwoofer to be mounted
2) Mark out & cut the correct diameter hole
3) Drill the holes for the mounting screws
4) Insert the subwoofer and affix with the appropriate screws
CP-SW100 CP-SW120
CS-SW100 CS-SW120
800 1000
200 250
33Hz - 1.2kHz 27Hz -1kHz
4 Ohms 4 Ohms
87dB 88dB
Pressed Paper Pressed Paper
Round Wound Round Wound
Copper Copper
120mm (4-23/32") 136mm (5-11/32") 142mm (5-19/32") 154mm (6 1/16")
228mm 277mm
(9") (10 15/16")
CP-SW100 CP-SW120
1000 1300
250 325
30Hz -1.2kHz 24Hz -1kHz
4 Ohms 4 Ohms
88dB 89dB
Pressed Paper Pressed Paper
Round Wound Round Wound
Copper Copper
228mm 277mm
(9") (10 15/16")
www.fusionelectronics.com