SUBWOOFERS
CS-SW100
CS-SW120
SPEAKER PARAMETERS
Peak Power (Watts)
Rated Power (Watts)
Frequency Response
Impedance
Sensitivity
Cone Material
Voice Coil Type
Mounting Depth
Mounting Diameter
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the amplifier, speakers or source unit.
Failure to do so could result in permanent damage to the audio system.
When wiring the subwoofer ensure that the wire is protected from sharp objects and always use rubber
grommets when wiring through metal panels. Ensure all terminals and connections are protected from the
vehicle chassis and from each other as failure to do so could result in permanent damage to the audio system.
When connecting the amplifier and subwoofer ensure you connect the positive and negative output wire from
the amplifier to the corresponding subwoofer terminals.
1) Ensure there is adequate clearance and depth for the subwoofer to be mounted
2) Mark out & cut the correct diameter hole
3) Drill the holes for the mounting screws
4) Insert the subwoofer and affix with the appropriate screws
CP-SW100
CP-SW120
CS-SW100
CS-SW120
800
1000
200
250
33Hz - 1.2kHz
27Hz -1kHz
4 Ohms
4 Ohms
87dB
88dB
Pressed Paper
Pressed Paper
Round Wound
Round Wound
Copper
Copper
120mm (4-23/32") 136mm (5-11/32") 142mm (5-19/32") 154mm (6 1/16")
228mm
277mm
(9")
(10 15/16")
CP-SW100
CP-SW120
1000
1300
250
325
30Hz -1.2kHz
24Hz -1kHz
4 Ohms
4 Ohms
88dB
89dB
Pressed Paper
Pressed Paper
Round Wound
Round Wound
Copper
Copper
228mm
277mm
(9")
(10 15/16")
www.fusionelectronics.com