Advertisement
IN S T A L L A T I ON F OR E L 2 5
C A M E RA MO D U LE M ODELS EL25BW CAM KT ,
EL 2 5 C CAM K T, A ND EL25DVRCAMKT
1
Disconnect power to the unit.
2
Unlock and open the unit.
3
To remove the LED board, unplug the wire harness from LED
board and remove the screws (3). Do not remove the rubber
O-ring.
4
Replace black plastic lens with the clear lens. Keep rubber
O-ring in place.
5
Install the camera module. Reconnect the LED board wire
harness to the camera module.
6
Feed a coaxial cable (not provided) through the conduit hole
in the back mounting plate of the unit. Connect a BNC coaxial
connector to the back of the camera module.
7
Close and lock the unit.
8
Reconnect power to the unit.
If the EL25 is connected to a home entertainment system,
NOTE:
the home entertainment system must be switched to video input.
FO R VER TIC AL L Y MOUNTED EL25 UNI T S
The camera lens board must be repositioned 90 degrees
counterclockwise before the above steps can be performed.
When repositioning the camera board carefully remove and set
aside the 2 mounting screws.
114A2972E
A static discharge can damage circuit boards.
3
Call Button
Board
4
5
Camera Module
© 2011, The Chamberlain Group, Inc.
All Rights Reserved
Wire Harness
Call Button
LED
Board
Board
Call Button
Call
LED
LED
Button
Board
Board
+
Board
Board
Clear Plastic Lens
O-ring
6
Rotated 90°
"Portrait" positioning for vertical mounting
+
Coaxial Cable
BNC Coaxial Connector
Advertisement
