Sansui HDPDP4200 Owner's Manual page 15

To connect the Plasma Display to a HDMI or a DVI device
The HDMI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital
video from a DVI device.
When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only the video signal. Separate
analog audio cords are required.
Rear lower of the Plasma Display
NOTE:
You must choose an appropriate setting for each connection (see page 32. "Selecting the HDMI audio input
source").
To connect the Plasma Display to a PC (Personal Computer)
Before you connect this Plasma Display to your PC, change the adjustment of your PC's Resolution and
Refresh rate (60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the
VGA connector PC MONITOR on the back of the Plasma Display. Attach the connectors firmly with the screws
on the plug. In case of a Multimedia computer, connect the audio cables to the audio outputs of your
Multimedia computer and to the AUDIO L and R connectors of the PC AUDIO (L/R) IN jacks of the Plasma
Display.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The Plasma Display can operate as the computer monitor.
Rear lower of the Plasma Display
To PC IN
Connections to other equipment
Audio cord (not supplied)
HDMI - to - DVI adapter cable
(HDMI type A connector)
(not supplied)
HDMI cable (type A connector)
(not supplied)
To PC AUDIO
IN jacks
Audio cord (not supplied)
VGA cable (not supplied)
DVI device
To DVI output
HDMI device
To HDMI out
Monitor Display modes
MODE Resolution
VGA 640x480
SVGA 800x600
SVGA 800x600
XGA 1024x768
To return to normal mode
Press INPUT SELECT again.
or
Refresh rate
60Hz
56.3Hz
60.3Hz
60Hz
15