Table of Contents
Advertisement
E Add detergent
The percentage amounts in the display
will help you to add the correct
percentage amount of detergent
recommended by the manufacturer.
40%
Add slightly less than half the
amount recommended . . .
50%
Add half the amount
recommended . . .
60%
Add slightly more than half the
amount recommended . . .
75%
Add three quarters of the
amount recommended . . .
100%
Add the full amount
You also need to take the level of
soiling and water hardness into
account.
too little detergent results in:
– Laundry not getting properly clean
and with time it may become grey
and hard to the touch.
– Greasy particles clinging to the
laundry.
– Limescale deposits on the heater
elements.
too much detergent results in:
– Excessive foam which causes a low
level of agitation and poor wash,
rinse and spin results.
– High water consumption (an
additional rinse cycle will
automatically switch in).
– A burden to the environment.
How to wash correctly
^ Pull out the detergent drawer and
add detergent to the compartments
as follows:
i
Detergent for the pre-wash
1
(add
/
of the total amount
4
recommended). This compartment is
also used for starch formulations
when starching separately.
j
Detergent for the main wash
including Soak
§
Fabric conditioner or liquid starch.
^ Close the detergent drawer.
See "Detergent" for further information
on detergent and the amount to
dispense.
17
Hide quick links:
Advertisement
Table of Contents
