Advertisement
Control Panel Guide
Rear Control Panel
Photocell On/Off
Model Lamp
Full/Proportional
Modeling Lamp
Control Switch
Sync Socket
Side Control Panel
Reflector
Release
Flash Power/
Model Lamp Control
4
calumetphoto.com
Carry handle
Photocell
Flash-Ready
Test/
Indicator
Open Flash
Operating Your Travelite
The Calumet Travelite may be operated either on an AC supply
or with a Calumet Travel-Pak
For AC operation, the AC switch (page 4) should be in the upper position I.
For battery operation the switch should be in the lower position II.
The center position is off.
AC / Battery
NOTE: When operated from a battery source, the modeling functions are not available.
Power Select
• Ensure the power source is off.
• Connect the unit using the appropriate cable.
AC Inlet
• If using the Travel-Pak, ensure the connector locks are fully tightened.
• Switch the power source on, then switch on the Travelite.
Fuse
• The unit will charge and indicate it is ready for use by illuminating the green flash-ready light.
(and Spare Fuse)
• Press the test button to check the unit fires.
Battery Power Inlet
WARNING HIGH VOLTAGE!
BOTH AC SUPPLY AND BATTERY SUPPLY AT THE SAME TIME. THIS
APPLIANCE MUST BE GROUNDED WHEN USED WITH AC. DISCONNECT
THE AC PLUG WHEN CHANGING MODELING LAMPS AND FLASH TUBES.
Mounting Your Travelite
Mount your Travelite
on a dependable
support system
The mount bushing on the
L-bracket allows for two
possible ways of mounting
to the stand/support (RIGHT).
Method B may be found
useful if the light is required
to point down.
Connecting and Using Your Travelite
NEVER CONNECT THE TRAVELITE TO
B
A
calumetphoto.com
5
Hide quick links:
Advertisement
