AEG OKO-LAVAMAT 1271 VI TURBO Instruction Booklet page 56

Building-in
c) Mounting the door
Fix the hinges (1) to the machine by means of the M5x8 screws (3-Fig. B).
The hinges can be adjusted to compensate for possible uneven thick-
ness of the door.
To align the door perfectly it is necessary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct oper-
6
ation of this device, it is necessary to screw
the counter-magnet (6) (steel disk + rubber
4
ring) into the inner side of the door.
Its position must correspond to the magnet (4)
on the appliance (see picture D).
8
D
If the door has to be opened from
left to right, invert the position of
6
the plates (7), the magnet (4) and
4
the plate (5) (Fig. B and E). Mount
the countermagnet (6) and the
hinges (1) as previously described.
1
5
7
Important: the plastic screw (8)
should never be loosened (Fig. B
3
and E).
8
E
2
56