Something Not Working - Tricity Bendix AW 1402 W User Manual

Something not working

IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red pilot light of button
the machine is not working.
Once the problem has been eliminated, press the button
checks, the problem persists, contact your local Service Centre.
Malfunction
The washing machine does not start:
The machine does not fill:
The machine fills then empties
immediately:
18
6
to restart the programme. If after all
Possible Cause / Solution
The door has not been closed. (Red pilot light of
button 6 flashes)
Close the door firmly.
●
The plug is not properly inserted in the power socket.
Insert the plug into the power socket.
●
There is no power at the socket.
Please check your domestic electrical installation.
●
The main fuse has blown.
Replace the fuse.
●
The selector dial is not correctly positioned and the
6
button has not been pressed.
Please turn the selector dial and press the button
●
again.
The water tap is closed. (Red pilot light of button 6
flashes)
Open the water tap.
●
The inlet hose is squashed or kinked. (Red pilot light
of button 6 flashes)
Check the inlet hose connection.
●
The filter in the inlet hose is blocked.(Red pilot light
of button 6 flashes)
Clean the water inlet hose filter.
●
The door is not properly closed. (Red pilot light of
button 6 flashes)
Close the door firmly.
●
The end of the drain hose is too low.
Refer to relevant paragraph in «water drainage»
●
section.
6
flashes to indicate that
6