Table of Contents
Advertisement
Problem
The washing machine
vibrates when operat-
ing or is not stable.
Water is leaking out
from under the
washing machine.
Softener was not
washed in.
ment for conditioners
is filled with water.
Washing is heavily
creased.
The door cannot be
opened when the ap-
pliance is switched on.
The
symbol appears
in the display.
The display goes out
while a wash cycle is
running.
The background illumi-
nation of the display
has gone out even
though the appliance is
switched on.
28
Possible cause
The transit packaging has not
been removed.
The screw feet not correctly
adjusted.
There is very little washing in
the drum (e.g. only one
bathrobe).
The screw connection on the
inlet hose is leaking.
The drainage hose is leaking. Replace drain hose.
The drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
The conditioner insert is not
compart-
correctly set into the addi-
tive compartment or is
blocked.
There may have been too
much washing in the ma-
chine.
The door is locked for safety
reasons.
Power cut.
For safety reasons, the door
will remain locked for ap-
prox. 4 minutes.
The washing machine is in
stand-by mode.
Remedy
Removing the transit pack-
aging.
Adjust the feet as described
in the installation and con-
nection instructions.
This does not affect how the
machine operates.
Screw the inlet hose in
firmly.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Clean the detergent dispens-
er drawer, insert the condi-
tioner insert firmly.
Observe maximum loads.
Wait until the
symbol ap-
pears.
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the
appliance, before opening
the door, first perform an
emergency drain.
Press any key.
Advertisement
Table of Contents
