Operation - Cary Audio Design Cinema 7B Owner's Manual

OPERATION ________________________________________________________

Your new Cinema Series power amplifier is ready for operation after installing the AC power cord, speaker
and interconnect cables. Make sure the RCA/XLR switch is in the proper input selector position for your
particular installation.
On-Off Power Switch
Push the main power switch on the front panel to the "ON" position for normal use. (Set it to OFF for
remote turn on/off operation and it will be turned on and off by the trigger in the surround sound
processor.) When turned on, LED's for each channel will light up. (Cinema 2 - 2, Cinema 5 - 5 and Cinema
7B – 7). You are ready at this point to play music or start the movie. Flip the main power switch to OFF for
normal shut down, and at this time one LED will light up for "standby" mode. This LED is located above the
ON/OFF switch.
Break In Period
The transistors and capacitors take approximately 100 hours of music playing to fully settle in for peak
performance. The power amplifier will sound good right out of the box and continue to improve as it goes
through 'break in.' After a couple of hours of play, you will notice increased depth and tighter bass.
8