Lenovo ThinkCentre Edge 91 User Manual page 51

Figure 20. Pivoting the drive bay assembly
5. Hold the hard disk drive and remove the four screws that secure the hard disk drive. Then, remove
the hard disk drive from the drive bay assembly.
Figure 21. Removing the hard disk drive
6. Disconnect the signal cable and the power cable from the hard disk drive to completely remove the hard
disk drive from the chassis.
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See "Locating parts on the system board" on page 12.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
.
Chapter 5 Installing or replacing hardware
39