Table of Contents
Advertisement
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Se lect
handle height best suited for your tilling conditions. Handle
height will be different when tiller digs into soil.
•
If a higher handle height is desired, loosen the four
nuts securing handle panel to engine brackets.
•
Slide handle panel to desired location.
•
Tighten the four nuts securely.
TINE ARRANGEMENT
Your outer tines can be assembled in several different ways
to suit your tilling or cultivating needs.
CAUTION: Tines are sharp. Wear
gloves or other protection when han-
dling tines.
NORMAL TILLING - 17" PATH (See Fig. 16)
•
Assemble holes "A" in tine hubs to holes "B" in tine
shaft.
CLEVIS
PIN
A
B
HAIRPIN CLIP
ENGINE
BRACKETS
HANDLE
PANEL
NUTS (ALSO 2
ON LEFT SIDE
OF TILLER)
FIG. 15
OUTER TINE
A
B
INNER TINE
FIG. 16
MID-WIDTH TILLING - 15" PATH (See Fig. 17)
•
Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
C
A
NARROW TILLING - 10-1/4" PATH (See Fig. 18)
•
Remove outer tines.
NARROW CULTIVATING - 12-1/2" PATH (See Fig. 19)
•
Remove inner tines.
•
Assemble holes "A" in tine hubs to holes "C" in tine
shaft.
A
C
EDGING - 9-5/8" PATH (See Fig. 20)
•
Remove inner tines.
•
Assemble holes "A" in tine hubs to holes "D" in tine
shaft.
A
13
C
A
FIG. 17
INNER TINES ONLY
FIG. 18
C
FIG. 19
D
D
FIG. 20
A
A
Advertisement
Table of Contents
