Cables And Connections - Focal Access 130 A1 User Manual

Access 2/3-WAy kit mAnuAl
U s e r
M a n u a l

Cables and connections

• For best results with your Access speakers, we recommend you include the use of
Focal cables.
• Alternatively, other high quality cable can be used, if sufficient section thickness is available
(minimum thickness = 1mm
ensure a strong efficient signal is maintained.
• Always ensure the polarity is respected, (+ is connected to +) and (- is connected to -).
• Maintain correct connections, from principal source radio / amplifier (left / right / front and
rear), and crossover to speakers (tweeter to tweeter), (mid to mid), (woofer to woofer), is
always observed.
• If the woofer is located at the bottom on the door, connect the woofer directly on the
amplifier in order to have more dynamic midrange.
Fitting the tweeter
There are two mounting possibilities available: surface or
flush mount. To easily install the tweeter, you have to turn
the pod round, then release the tweeter.
Surface mounting (dashboard): choose the angle that
best suits your installation (10° or 30°) and mount the pod
firmly using the screws supplied. Feed the wire through
the hole in the pod and re-fit the tweeter in place.
Flush mounting: cut a neat 45mm diameter hole in the
panel where you want to place the tweeter. Then, insert
the tweeter in the front panel. In the same time, put the
lock washer in the rear panel. Feed the wire through the
hole and push simultaneously on the pod and the washer
to lock the pod on the panel. Feed the wire through the
hole in the pod and re-fit the tweeter in place.
). This is particularly important for long lengths of cable to
2
Right Output Input
Left Output Input
Woofer
Tweeter
Woofer
Tweeter
Tweeter
Pod
Screw
lock washer
3