Specifying The Type Of Operation (Source Mode); Connecting To External Pedals - Boss Audio Systems Boss Loop Station RC-300 Owner's Manual

Phrase Memory Settings
Parameter
Assign1 Src Mode

Connecting to External Pedals

Connect your EXP pedals (EV-5
The function of the external pedal (EXP pedal or foot switch) can be assigned independently for each phrase memory. For details, refer to "Assigning
the Function of Pedals and External Controllers (Assign)" (p. 23).
When Connecting EV-5s
EXP 3
* Use only the specified expression pedal (Roland
EV-5, etc. ; sold separately). By connecting
any other expression pedals, you risk causing
malfunction and/or damage to the unit.
Default assignments of functions controlled
The default assignments are as follows. If you simply connect pedals without making any settings, you can use them to control the following
parameters and functions.
Assign Switch
Assign1 ON
Assign2 ON
Assign3 ON
Assign4 ON
Assign5 ON
Assign6 ON
Assign7 ON
Assign8 OFF
24
Value

Specifying the Type of Operation (Source Mode)

MOMENT
If a momentary-type foot switch (such as the separately sold FS-5U) is connected as the source, you can specify how
foot switch operations will affect the value.
* If the [LOOP FX] pedal is set to MOMENT, it will no longer be possible to enter Pedal Function mode (p. 10) by
holding down the [LOOP FX] pedal for two seconds or longer.
MOMENT
TOGGLE
; available separately) or foot switches (FS-5U, FS-6; available separately) as shown in the illustration.
, etc.
When Connecting FS-5Us
Red White
EXP 2 CTL 4
* If you use a mono cable to connect a single FS-5U, the CTL 1, 2 jack will be CTL 1, and the CTL 3, 4 jack will be CTL 3.
Assign Source
EXP1 PEDAL
EXP2 PEDAL
CTL1 PEDAL
CTL2 PEDAL
CTL3 PEDAL
CTL4 PEDAL
SYNC START/STOP
Explanation
The setting will normally be off (minimum value); it will be on (maximum value) only while
you continue holding down the foot switch.
The setting will alternate between off (minimum value) and on (maximum value) each time
you press the foot switch.
Cable:
Stereo 1/4" phone
type fg
1/4" phone type x 2
Red White
CTL 3 CTL 2 CTL 1
POLARITY switch
Assign Target Explanation
The effect that's most suitable for the selected LOOP FX type will be
EFFECT CONTROL
applied.
Level The pedal will control the volume of the phrase memory.
MEMORY INC
The pedals will switch phrase memories.
MEMORY DEC
FX TYPE INC
The pedals will switch the LOOP FX type.
FX TYPE DEC
All tracks can be simultaneously played/stopped upon reception of
ALL PLAY/STOP
ALL START/STOP messages from the master RC-300 unit (p. 39).
When Connecting FS-6s
Cable:
Stereo 1/4" phone
type fg
Stereo 1/4" phone type
CTL 4 CTL 3 CTL 2
MODE/POLARITY switch
CTL 1