Step 5. Using the enclosed magnetic
screwdriver, remove the two (2)
screw s from the optical drive you are
rep lacing. (In this example: the lower
optical drive.)
2
1
Step 8. Using the enclosed magnetic
screwdriver, reinstall the previously
removed screws following the above
seq uence. (In this example: the lower
optical drive.)
IMPORTANT! Do not
over tighten the screws!
Step 10. Reinstall the front panel to its
original position , as shown.
P/N 994630200
Rev. C
VGC-RBxx Series Optical Disk Drive
Lower Replacement Instructions
Step 6. Pull out the original optical drive
from the chassis in the direction of the
arrow.
[1]
Step 9. Reconnect the IDE data cable [ 1] and the power cable [2] to the new optical disk
drive you have replaced. (In this example: the lower optical drive.)
Step 11. Reinstall the left chassis cover panel in the direction of arrow. Then using the
enclosed magnetic screwdriver, reinstall the two (2) previously removed screws.
IMPORTANT! Do not over tighten the screw s!
Sony following the included shipping instructions
2/2
Step 7. Carefully slide the new optical
drive into the newly vacant space in the
chassis, making sure the screw holes are
aligned.
[2]
2
Screws
Return the original optical disk drive to