3.17
Feed Dog Height
Adjustment
Caution
If the screw '2'
is tightening
too much, the
crank '1' will
be worn out.
When the feed dog 'A' is at its high-
est position, the teeth should be
above the top surface of the throat
plate 'B' as the below height for
each machine variety (Figure 26).
High Speed Straight Lockstitch Sewing Machine
Loosen screw '2' of crank '1'.
Move the feed bar up or down to
make a correct height.
Securely tighten screw '2'.
See description below for height
Figure 26
|
Instruction Manual and Parts List
17