Canon PowerShot A2500 User Manual page 96

Cannot magnify!/Cannot rotate/Cannot modify image/Cannot modify/
Cannot assign to category/Unselectable image.
• The following functions may be unavailable for images that were renamed or already
edited on a computer, or images shot with another camera. Note that starred (*)
functions are not available for movies.
Magnify* (= 64), Rotate (= 68), Edit*
and Photobook Set-up* (= 88).
Exceeded selection limit
• Print List (= 86) or Photobook Set-up (=
correctly. Reduce the number of selected images and try again.
Communication error
•
An excessive amount of images (approx. 1,000) on the memory card prevented
printing or image transfer to a computer. To transfer the images, use a commercially
available USB card reader. To print, insert the memory card directly into the printer
card slot.
Naming error!
• The folder could not be created or images could not be recorded, because the highest
supported folder number (999) for storing images on the card has been reached and
the highest supported image number (9999) for images in folders has been reached.
In the [3] menu, change [File Numbering] to [Auto Reset]
memory card (= 74).
Lens Error
• This error may occur if the lens is held while it is moving, or when the camera is used
in dusty or sandy locations.
•
Frequent display of this error message may indicate camera damage. In this case,
contact a Canon Customer Support Help Desk.
A camera error was detected (error number)
• If this error message is displayed immediately after a shot, the image may not have
been saved. Switch to Playback mode to check for the image.
• Frequent display of this error message may indicate camera damage. In this case,
write down the error number (Exx) and contact a Canon Customer Support Help
Desk.
(= 69 – 71), Print List* (= 86),
88) settings could not be saved
(= 75), or format the
File Error
• Correct printing (= 83) may not be possible for photos from other cameras or
images that have been altered using computer software, even if the camera is
connected to the printer.
Print error
• Check the paper size setting (= 85). If this error message is displayed when the
setting is correct, restart the printer and complete the setting on the camera again.
Ink absorber full
• Contact a Canon Customer Support Help Desk to request assistance with ink
absorber replacement.
Cover
Preliminary Notes and
Legal Information
Contents:
Basic Operations
Basic Guide
Advanced Guide
1
Camera Basics
2
Smart Auto
Mode
3
Other Shooting
Modes
4
P Mode
5
Playback Mode
6
Setting Menu
7
Accessories
8
Appendix
Index
96