Advertisement
OPERATING
INSTRUSTIONS..........................................
1. Start up
Fill the wat er tank with fresh clean wate r, pure water is strongly recommended to
avoid scale in the machine, and the water level should no lower than the Min. position
and no higher than the Max. position.
Switch on the machine at the On/Off switch and then it will be illuminated.
Check the below procedure of cof fee/ espresso brewing or inside system cleaning
before first use.
2. Coffee/Espresso brewing
To get a cup of coffee, please firstly insert the capsule into the capsule holder
according to the shape and direction by moving the slidable cover on the top to open
and close.
Turn the Coffee/Steam knob clockwise to the coffee position, and then the system will
pre-heat with a blinking round blue indicator on the front control button.
Please press the front control button when t he indicator stops blinking to get cof fee
with a desired volume.
Then press the front control button again or turn back the knob to 0 position to stop
outputting the coffee; the round blue indicator goes off.
The capsule will drop into the waste capsule collection container automatically in
several seconds only in the case of turning back the Coffee/Steam knob to 0 position.
3. Steaming and Frothing
Make sure the capsule holder cover is closed, and turn the Coffee/Steam knob
counter-clockwise to the steam position. The Coffee/Steam indicator will change to
red color and blink to pre-heating.
Please press the front contro l button when the indicator stop s blinking, and steam
begins to dispense from the steam nozzle continuously.
Please press the front control button again or turn the knob to 0 position to stop
steaming; the red indicator goes off.
Please remember to turn back the knob to 0 position finally.
Note:
Do not wait too long before cleaning the steam wand. Milk deposits are hard to remove.
Once the froth has been made, we recommend placing a cup of water under the steam
wand and starting the steam dispensing function again for a few 1-2seconds. This way,
any residue of milk will be easily removed from the nozzle
Advertisement
