Gigabyte GA-P55-UD5 User Manual page 92

Recovery Volume Options
Intel Rapid Recover Technology provides data protection by allowing users to easily restore data and system
operation using a designated recovery drive. With the Rapid Recovery Technology, which employs RAID 1
functionality, users can copy the data from the master drive to the recovery drive; if needed, the data on the
recovery drive can be restored back to the master drive.
Before you begin:
• The recovery drive must have equal or greater capacity than the master drive.
• A recovery volume can be created with two hard drives only. A recovery volume and a RAID array cannot
co-exist in the system at the same time, that is, if you have already created a recovery volume, you are
unable to create a RAID array.
• By default, only the master drive can be riewed in the operating system; the recovery drive is hidden.
Step 1:
select Create RAID Volume in MAIN MENU and press <Enter> (Figure 8).
1. Create RAID Volume
2. Delete RAID Volume
RAID Volumes :
None defined.
Physical Disks :
Port Drive Model
0 ST3120026AS
1 ST3120026AS
[ hi ]-Select
Step 2:
After entering the volume name, select Recovery under the RAID Level item and press <Enter> (Figure 9).
[ hi ]-Change
Appendix
Intel(R) Matrix Storage Manager option ROM v8.9.0.1023 PCH-D wRAID5
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
[ DISK/VOLUME INFORMATION ]
Serial #
3JT354CP
3JT329JX
Intel(R) Matrix Storage Manager option ROM v8.9.0.1023 PCH-D wRAID5
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
[ CREATE VOLUME MENU ]
RAID Level : Recovery
Strip Size : N/A
RAID0: Stripes data (performance).
RAID1: Mirrors data (redundancy).
Recovery: Copies data between a master and a recovery disk.
RAID10: Mirrors data and stripes the mirror.
RAID5: Stripes data and parity.
[TAB]-Next
[ MAIN MENU ]
5. Exit
Size
111.7GB
111.7GB
[ESC]-Exit
Figure 8
Name : Volume0
Disks : Select Disks
Capacity : 0.0 GB
Sync : Continuous
Create Volume
[ HELP ]
Choose the RAID level:
[ESC]-Previous Menu
Figure 9
- 92 -
3. Reset Disks to Non-RAID
4. Recovery Volume Options
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
[ENTER]-Select Menu
[ENTER]-Select