Gigabyte GA-Z68X-UD5-B3 User Manual page 82

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). To
create RAID, set PCH SATA Control Mode under the Integrated Peripherals menu to RAID(XHD) (Figure 1)
(IDE by default). If you do not want to create RAID, set this item to IDE or AHCI.
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
eXtreme Hard Drive (XHD)
PCH SATA Control Mode
SATA Port0-3 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Azalia Codec
Onboard H/W 1394
Onboard H/W LAN
 SMART LAN
Onboard LAN Boot ROM
Onboard USB3.0 Controller
USB3.0 Turbo
eSATA3 Controller
eSATA3 Ctrl Mode
eSATA3 Transaction Mode
eSATA3 RAID Configuration
SATA3 Firmware Selection
higf: Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
Integrated Peripherals
[Disabled]
[RAID(XHD)]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled]
[Enabled]
[Press Enter]
[Disabled]
[Enabled]
[Disabled]
[Enabled]
[IDE]
[Fw Mode]
[Press Enter]
[Auto]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 82 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults