AIR CLEANING OPERATION
If you wish to eliminate dirt,dust,cigarette smoke, pollen, or just simply purify the
air of the room, use the Air Cleaning Mode.
Press the START/STOP button (Fig. 6 S).
1
The OPERATION Indicator Lamp (red) (Fig. 3 5) will light.
(If the unit is already in operation, please proceed to step 2.)
Press the AIR CLEAN button (Fig. 6 L).
2
The AIR CLEAN Indicator Lamp (orange) (Fig. 3 7) will light up.
● Air conditioning and Air Cleaning will function simultaneously.
If you wish to stop Air Clean
Press the AIR CLEAN button (Fig. 6 L) once again.
The AIR CLEAN Indicator Lamp (orange) (Fig. 3 7) will go out.
● This will only stop the Air Cleaning, the air conditioner will continue operating.
To also stop the air conditioner
Press the START/STOP button (Fig. 6 S).
The OPERATION Indicator Lamp (red) (Fig. 3 5) will go out.
● The next time the START / STOP button (Fig. 6 S) is pressed air conditioning
and air cleaning will both resume operating.
Air cleaning
●
During operation, the unit produces a small amount of ozone that can be smelled.
●
When this unit is used in combination with the ultrasonic humidifier, white parti-
cles may become attached to the plasma filter unit. If this happens, clean the
plasma filter unit as soon as possible. (Refer to page 14, 15.)
●
The air cleaning operation cannot remove gases such as carbon monoxide and
alcohol from the air. During operation, ventilate the room often to prevent as-
phyxiation or suffocation.
●
If the intake filter is removed during operation, a safety device will stop the op-
eration of the plasma filter unit. If this happens, the AIR CLEAN Indicator Lamp
(orange) on the indoor unit will flash after some time has passed. Use the START/
STOP button on the remote controller to stop the operation, install the intake
filter, and then use the START/STOP button to restart the operation.
●
Use the FAN CONTROL button to change the fan speed. (Refer to page 5.) The
plasma filter unit operates most effectively at the highest fan speed.
●
The AIR CLEAN Indicator Lamp (orange) will flash to inform you that the periodic
cleaning of the plasma filter unit is required. (Refer to page 14, 15.)
8