The measurement process starts with the pumping up
of the sleeve.
To break off the measurement process press the
button
START / STOP
During measurement, air is gradually released from the
sleeve. If the measurement fails at this point, the appli-
ance may pump some more air into the sleeve. If a
measurement is taken successfully, the remaining air is
released and the display shows ...
the „systolic" blood pressure at the top, in healthy
adults it lies between about 105-140 mmHg,
the "diastolic" blood pressure in the middle, in
healthy adults it lies between about 60-90 mmHg,
the pulse measurement at the bottom.
The m easured blood pressure as well as the program-
med limit values are displayed alternatively. Should a
limit value be exceeded (SYS or DIA) the appropriate
value flashes in the display. Press the button
START / STOP
possibly alter the programmed values.
The appliance is equipped with an automatic switch-off.
Should a button not be activated within one minute,
the appliance switches itself off. Press the button
START / STOP
again.
to change over to the Start display and
, to switch the appliance back on.
13